Видео

That trailer needs new tires. Forgot the screw, go straight to Discount Tire.

I have disconnected my smoke alarm it has a battery draw but not a battery connecting in it other than the wire coming from the ceiling part, and that is where it is still beeping from. DO you have an answer for that?

Did you use a New/different wago for the second test? But if this will endure up to 20lbs then I do not see an issue. A current test would be nice to see.

Those gaps are there for a reason

Very helpful video. Thank you!!

Surprised he didn't address all of the comments on the original video indicating that 1" conduit should have be used for the 6-3 Romex as opposed to 3/4" (or use THHN in the 3/4" conduit).

When you get started with and you cut the rail to where you want it. How do you know how many pieces of the blind go up. We did this once and there was to many pieces of blinds and they over lapped on one end. Is there a way to figure this out?

I moved into a house and none of the outlets are grounded. The 3 prong outlet is just for show

This is a really great video. However, in my case, there isn't anything that looks like that capacitor. The unit is a Rheem, installed in 2008. I honestly believe that this is my problem, but just don't see anything that resembles that capacitor.

Looks like shit though

Is that actually water tight between the seal and the pipe? Seems like it would need some caulking around that top edge.

You're lucky you live in an area where you can shutoff your water from the curb. We had an old valve like yours. I was repairing another faucet and turned off the water valve. Went to turn it back on and leaking like crazy. Turned it off and leaked even more. Did the packing trick like you said and called a plumber...well plumber said "ok looks like it will hold" then turned it an 8th of a turn and bam! Huge rush of 90psi water everywhere in the flooded basement. He was able to get it settled down to about 15psi and used a hand pump to get the water out psi while the water authority came within an hour and had to shut off the water mains, which in New England are like 8 feel below ground. Huge mess, but ended well with two ball valves (one before the inside meter and one after) along with a reducer to bring it down to 60psi. I've never use these valves again. Ball valves all the way.

Very much worth mentioning to ALWAYS turn the gasoline valve off and let the engine run out of gas before putting the PW away for more than a few hours. Gas sitting in the carburetor is the main cause of hard starting next time around.

Premature baby has green eyes and early evidence of dying early. Here’s some tape while fucking with the HVAC. DiY is a low I suppose.

When a guy brings out the incense you already know that his house smells like urine.

Thank you for being kind enough to provide all the details.

why damn RUclips remove my comment ? You can save money to buy on TEMU $72.47. On Amazon for same you pay $120 right now. It's my last year on PRIME.I don't want to pay any more Prime, It's a waste money.

It's basically formica ? Laminate is a term more adapted to floors.

Too much work! I found that in the morning ,pouring one container of Salt into a gallon of white vinegar and leaving that in the sun to dissolve during the day, by evening i just pour it into an empty bottle of catsup and squeeze that chit right onto thise cracks and Boom!! By morning those suckas are all dead! This lastes me all year and on the side where theres no water sprinkles to wash off the salt, i haven't needed to reapply in 5 years. Or you could just eat those weeds with a side of lafa beans You're welcome madafakas! But don't call me as you hear those weeds screaming over night keeping you up, Clarice!!!

Are you saying "clay sand" or "play sand", and where can I buy it?

Flush time went from 3 min 36 seconds to 1 min 16 seconds. Well worth the $2 and under 10 minutes investment!!

He said, "Measure your crack"😂 3:31

You are honest, I like that. One of the few.

Is there a way to keep wasps from building a nest under the frame? That's kind of my biggest concern right now cause i was planning on doing the same thing as you did.

What kind of flange do you use to cover the outside standoff pipe clamp?

100% Levernuts for lighting! I stopped using wire nuts a few years ago after watching a few UT videos that show which wire device system could handle the most current before failing.

It blows my mind how many people watch "How To" videos but then proceed to tell YOU how to do your job lol I mean, the thr fuck are you watching HOW TO videos if your such a Pro? Lol... I appreciate you taking the time to make this video dude, I was fairly sure how to do it myself just wanted some tips and I got some from this video. Thank you 🤟🇨🇦

Please I need an alternative to a caulking gun....way too hard to use with arthritis!....???? Thank You

20 minutes are way too short test. Electrical installation should keep as safe for decades, not for minutes. Also Wago does vibration tests with many different conditions. Beside 221 series, there is a 2273, which is very thin in comparison to 221. Theoretically 2273 is one time use, but practically You can remove wire multiple times. Anyway, many people complaining to them, cant read very short manual at the back and they strip wire insulation less than recommended 11 mm. Always read manuals before first use - electrical current is not a toy.

Clay Sand? Sooo many kinds of sand out there...Can Quikrete Medium Grade Sand be used? Or Play Sand? thank you!

I open the top of the units and vacuum any debris that fell in. Then I spray the cleaner from both sides of the coils and let it sit for about 5 to 10 minutes. I use the shower setting on the hose and flush it from inside out to assure the debris isnt pushed into the coils.

This can be done only in the US

YES YES to details!

A superior back-up to complement the Delta Pro would be a dual-fuel inverter generator. Fuel flexibility and recharging on your own schedule, especially in the cold weather, would be a bonus. I am considering this set-up as a back-up for my own modest family home here in Alberta. Thinking about my neighbours, too.

Reading the comments, I want to say, be wary of anyone who tells you it is better to have a lower confidence tire on the rear of the vehicle. If they think a blowout on the rear is safer than a blowout on the front, they for sure are NO expert!

You are aware that you don’t have a 9500watt Wgen you have a 7500 watt unit and a 9500 watt Wgen has a 50 amp outlet. You wouldn’t have to gat a 12000 watt Wgen to have a 50 amp outlet. What did you do about having a bonded neutral Wgen? Is your service panel compatible with that? Or did you change the ground wiring in your gen.

Is there an easy way to tell which outlet i is the first in the series in a room so i know which outlet needs to be swaped to a gfci?

Where I live now I don't have a driveway. Just ruts in the yard.

When I was a kid and played with dinosaurs, the fill valve use to take up to 3 minutes or more to fill the tank up, and that was brand new and good working order. Even in a family household, it was rare that a toilet needed to be flushed two or more times in a row.

Great work, man. How has it held up so far?

I’m glad you go into the different boxes to mount your fan or light but give option to go forward

The amount of detail you have in your videos is great. I wouldn’t feel comfortable doing this if you didn’t have this level of detail.

construction all my life. I'm 69 years old. done a lot of electrical. never would of thought of that nor never seen it. That was cool as hell

Horrible marking. Eyeballing the distance from the wall. Didn't mark left and right. Just threw the circle on it. Got lucky.

Great information. You may have saved me some money.

Step 1 & 2 haven’t worked and now going to buy the air compressor to see if that helps.

Thank you..perfect video

Thank you so much! It was the wiring in the pad and I was able to get a new one on Amazon. Thanks!

I have a Crawlspace and my hoses were removed in the Fall and spigot protected with covers. I hooked up my hoses over the weekend and the frost free is leaking from under the cap. I live in NJ and was wondering how much a plumber should charge for a replacement spigot. I have never been under my crawlspace and my husband died 3 years ago. Help please!!!

Some toilets just are poorly made.